I need a PCB design to hold a Pixhawk V6X autopilot cube
Breaking out my only needed functions to accept 2.5mm ferruled wires: c1 power c2 power gps 2 can 1 can 2 telem 2. And A1 power gnd and sensor Also require a USB-C and RJ45 on board also.
Nice to haves: Can 1 and Can 2 have LED to show correct wiring (green), bad wiring (red)
All the pinouts and specifications for the pixhawk autopilot and breakout are freely available online
I require from this a finished schematic/design/bom etc that I can send off to get the PCBs manufactured so that I can populate and solder In house